Serving all 464 cities in Alabama · open 24 hours
Broken springs, dead openers, snapped cables, doors off the track and new door installation. Same-day appointments most days and a phone line answered at any hour.
Flat pricing · parts carried on every truck · residential and commercial
Repair, replacement and installation for residential and commercial doors. Each service has its own page for every city we cover in Alabama.
Doors that won't open, won't close, bind, grind or hang crooked.
Broken torsion and extension springs replaced same day, in matched pairs.
Openers that hum, reverse, click once, or ignore the remote entirely.
Snapped cables, doors hanging off the track, drums that unwound.
A door stuck open at midnight is a security problem. We answer 24/7.
New steel, insulated and carriage-house doors measured and fitted.
Dented, rusted or storm-damaged doors swapped for a new sectional door.
Rolling steel, sectional and dock doors for shops, fleets and warehouses.
Belt, chain and wall-mount openers installed and programmed.
Single dented panels, cracked sections, worn nylon rollers.
A 21-point service that stops most breakdowns before they start.
R-9 to R-18 doors for garages people actually work in.
You do not need a diagnosis to call. Describe the symptom and we will usually narrow it down before we arrive.
Any of the above, call (877) 230-8979. If the door is hanging off the track or a spring has snapped, stop using the opener.
Describe the noise or the symptom. Most doors can be narrowed down to a spring, cable, opener or track problem over the phone.
You get a flat number for the repair, including parts and labour, before a tool comes out of the truck.
Springs, cables, rollers, sensors and common opener parts are on the van, so most jobs finish the same trip.
We cycle the door, set the opener force and travel, test the safety reverse and clean up before leaving.
We run trucks across the whole state. Pick your city for local pricing, services and a map of the area we cover.
★★★★★Spring snapped Sunday night and my truck was locked in. Someone answered at 11pm, was out by 7am and had both springs on before I left for work.
Marcus D.Alabama · Spring replacement
★★★★★Door had been screeching for a year. Turned out to be rollers and a dry torsion bar. Quiet now and it cost far less than I had talked myself into.
Yvonne T.Alabama · Tune-up and rollers
★★★★★The opener kept reversing at the last inch. He found a bent sensor bracket in about four minutes and did not try to sell me a new opener.
Ray P.Alabama · Opener repair
★★★★★Backed into my own door. They matched the panel, replaced it the following afternoon and it looks like nothing happened.
Danielle H.Alabama · Panel replacement
★★★★★Old wooden door finally gave up. New insulated steel one went in in a day and the garage is noticeably cooler in the afternoon.
Curtis A.Alabama · New door installation
★★★★★Cable came off the drum and the door was hanging sideways. They told me not to touch it, showed up the same afternoon, had it back on track and balanced.
Sondra L.Alabama · Cable and off-track
Most Alabama calls booked before mid-afternoon get a same-day slot, and anything urgent, a door stuck open or a car trapped inside, moves to the front of the list. The phone line is answered 24 hours.
Common repairs run roughly $120 to $380. Spring replacement usually falls in the $180 to $420 range for a matched pair. You get a flat number before any work starts, not an estimate that grows.
We can, but we do not recommend it. Springs wear at the same rate, so if one has gone the other is close behind. Replacing the pair costs less than paying for a second call-out in a few months.
Nine times out of ten it is the safety sensors near the floor: knocked out of alignment, dirty lenses or a loose wire. It can also be the down-force setting or something in the track. Both are quick fixes.
Yes. Rolling steel shutters, sectional overhead doors, high-cycle spring systems and jackshaft openers for shops, warehouses and fleet yards, including after-hours visits so you do not lose trading time.
If the panels are sound, repair is almost always the better value. Once you have rust through the bottom section, cracked stiles or multiple dented panels, replacement usually costs less over five years.
Yes. If you have bought an opener already we will fit it, program the remotes and keypad, set the travel limits and force settings, and test the safety reverse before we leave.
All the common ones: Clopay, Amarr, Wayne Dalton, Overhead Door and Raynor doors, plus LiftMaster, Chamberlain, Genie, Craftsman and Linear openers.
Tell us what the door is doing and we will tell you what it costs. Same-day slots most days, emergency calls answered 24 hours.
(877) 230-8979